Now, you can ping both ways with the following commands: Alpine Linux appliance ( AlpineLinux-1): 10.0.0.1.The setup of our IP addresses looks like this: With everything set up correctly, we will make both appliances ping each other, to verify their connection. To verify the IP address we’ve set up for StoneWork, type in show int addr : vpp# show int addr.Name Idx State MTU (元/IP4/IP6/MPLS) Counter Count You should see, that the State of eth0 is up vppctl To double-check the settings in the VPP data-plane, type in vppctl into the same Terminal window, then show int.SEQ TYPE START INPUT OPERATIONS RESULT SUMMARYġ config replace 44m 30 values CREATE:5 ok CONFIGURED:5Ģ status update 43m 1 values CREATE:1 ok OBTAINED:1ģ status update 43m 1 values CREATE:1 ok OBTAINED:1Ĥ status update 43m 1 values CREATE:1 ok OBTAINED:1ĥ status update 43m 1 values CREATE:1 ok OBTAINED:1Ħ status update 43m 1 values CREATE:1 ok OBTAINED:1ħ config replace 5m 35 values CREATE:3, UPDATE:1 ok CONFIGURED:4Ĩ status update 5m 2 values CREATE:1, DELETE:1 ok OBTAINED:1, REMOVED:1 Type in the following command to the Auxiliary console of StoneWorkmin-1:.We have successfully set up the configuration of StoneWork! Now, we will verify the update in StoneWork.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |